LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 176 (Engine Control System (2GR-FSE) - System And Component Testing, On-Vehicle Inspection, Removal, Inspection & Installation) >> Crankshaft Position Sensor >> Removal

Crankshaft Position Sensor: Removal

WARNING: This page is about a different car, the 2008 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE COOL AIR INTAKE DUCT SEAL  (See REMOVAL )
  2. REMOVE V-BANK COVER SUB-ASSEMBLY  (See REMOVAL )
  3. REMOVE NO. 1 INLET AIR CLEANER  (See REMOVAL )
  4. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM  (See REMOVAL )
  5. REMOVE V-RIBBED BELT  (See REMOVAL )
  6. REMOVE ENGINE UNDER COVER 
  7. REMOVE REAR ENGINE UNDER COVER LH 
  8. DISCONNECT NO. 1 COOLER REFRIGERANT SUCTION HOSE  (See REMOVAL )
  9. DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY  (See REMOVAL )
  10. REMOVE COMPRESSOR WITH PULLEY ASSEMBLY  (See REMOVAL )
  11. REMOVE CRANKSHAFT POSITION SENSOR 
    1. Disconnect the crankshaft position sensor connector.
    2. Remove the bolt and crankshaft position sensor.
    Fig 1: Locating Crankshaft Position Sensor Connector And Bolt
    G04973878Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals