LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Cooling) >> Thermostat >> Installation

Section 14 (Cooling): Thermostat: Installation

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL WATER INLET SUB-ASSEMBLY WITH THERMOSTAT 
    1. Install a new gasket and the water inlet sub-assembly with thermostat with the 3 nuts

      Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

    Fig 1: Locating Water Inlet Sub-Assembly Nuts
    G04948176Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. CONNECT NO. 2 RADIATOR HOSE  (See INSTALLATION )
  3. ADD ENGINE COOLANT  (See REPLACEMENT )
  4. INSPECT FOR COOLANT LEAK  (See COOLING SYSTEM )
  5. INSTALL NO. 1 AIR CLEANER INLET  (See INSTALLATION )
  6. INSTALL COOL AIR INTAKE DUCT SEAL  (See INSTALLATION )
  7. INSTALL ENGINE UNDER COVER 
scientia non olet · About LEMON Manuals