Drive Belt: Installation

INSTALL V-RIBBED BELT
1. Install the V-ribbed belt.
2. While turning the belt tensioner counterclockwise, remove the bar.
  NOTE:
  - Put the backside of the V-ribbed belt on the tensioner pulley and idler pulley.
  - Check that the V-ribbed belt is properly set to each pulley.
    
    Fig 1: Turning Belt Tensioner
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. If it is difficult to install the V-ribbed belt, perform the following procedure.
  1. Put the V-ribbed belt on every part except the tensioner pulley as shown in the illustration.
  2. While releasing the belt tension by turning the belt tensioner counterclockwise, put the V-ribbed belt on the tensioner pulley.
    NOTE:
    Put the backside of the V-ribbed belt on the tensioner pulley and idler pulley.
    
    Check that the V-ribbed belt is properly set to each pulley.
    
    Fig 2: Identifying V-Ribbed Drive Belt Routing
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL V-BANK COVER SUB-ASSEMBLY (See INSTALLATION )
INSTALL NO. 1 INLET AIR CLEANER (See INSTALLATION )
INSTALL COOL AIR INTAKE DUCT SEAL (See INSTALLATION )