Navigation Ecu: Removal

EJECT MAP DISC
1. Turn the engine switch on (ACC).
2. Apply protective tape to the places shown in the illustration.
  
  Fig 1: Identifying Protective Tape To Places
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Insert 2 precision screwdrivers ( 1.5 or less) into the holes on both sides of the clock assembly at the angle shown in the illustration.
  NOTE: Do not pry on the clock assembly with the screwdrivers as it may damage the clock assembly.
  
  HINT:
  
  If precision screwdrivers are not available, use in-vehicle tools (part No. 09135-53010).
  
  Fig 2: Identifying Holes On Both Sides Of Clock Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Insert a protective taped screwdriver from the underside of the hazard switch and pull and remove the clock assembly.
  NOTE:
  - Do not pry on the hazard switch with the screwdriver as it may damage the switch.
    
    Fig 3: Removing Clock Assembly
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Remove the 2 precision screwdrivers.
6. Push the "MENU" button.
7. Touch "Map DVD" on the navigation screen.
8. Touch "EJECT DVD" on the navigation screen to eject the map disc.
9. Temporarily reinstall the clock assembly to make the removal of the multi-display assembly easier.
  NOTE: Do not install the clock assembly completely because it will be removed later.
10. Turn the engine switch off.
REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Automatic Transmission) (See REMOVAL )
REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transmission) (See REMOVAL )
REMOVE UPPER NO. 1 CONSOLE PANEL GARNISH (for Automatic Transmission) (See REMOVAL )
REMOVE UPPER NO. 2 CONSOLE PANEL GARNISH (for Automatic Transmission) (See REMOVAL )
REMOVE CONSOLE PANEL SUB-ASSEMBLY (for Automatic Transmission) (See REMOVAL )
REMOVE REAR CONSOLE PANEL SUB-ASSEMBLY (for Manual Transmission) (See REMOVAL )
REMOVE FRONT CONSOLE PANEL SUB-ASSEMBLY (for Manual Transmission) (See REMOVAL )
REMOVE FRONT ASH RECEPTACLE SUB-ASSEMBLY (See REMOVAL )
REMOVE CONSOLE BOX REGISTER ASSEMBLY (See REMOVAL )
REMOVE CONSOLE BOX (See REMOVAL )
REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY (See REMOVAL )
REMOVE CENTER LOWER INSTRUMENT CLUSTER FINISH PANEL (See REMOVAL )
REMOVE MULTI-DISPLAY WITH RADIO RECEIVER ASSEMBLY (See REMOVAL )
REMOVE NO. 1 RADIO BRACKET (See REMOVAL )
REMOVE NO. 2 RADIO BRACKET (See REMOVAL )
REMOVE MULTI-DISPLAY ASSEMBLY
1. Slide the multi-display in the direction shown by the arrow to remove the multi-display assembly.
  
  Fig 4: Sliding Multi-Display
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE NAVIGATION ECU
1. Disconnect the connectors.
  
  Fig 5: Identifying Navigation ECU
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the 4 bolts and navigation ECU.
  
  Fig 6: Removing Navigation ECU
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002