LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Exterior Lights >> Lighting >> Headlight Dimmer Switch >> Removal

Headlight Dimmer Switch: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait for 90 seconds after disconnecting the cable to prevent airbag deployment (See PRECAUTION )
  2. REMOVE NO. 2 LOWER STEERING WHEEL COVER  (See REMOVAL )
  3. REMOVE NO. 3 LOWER STEERING WHEEL COVER  (See REMOVAL )
  4. REMOVE STEERING PAD  (See REMOVAL )
  5. REMOVE STEERING WHEEL ASSEMBLY  (See REMOVAL )
  6. REMOVE STEERING COLUMN COVER (for Power Tilt and Power Telescopic)  (See REMOVAL )
  7. REMOVE STEERING COLUMN COVER (for Manual Tilt and Telescopic)  (See REMOVAL )
  8. REMOVE SPIRAL CABLE WITH STEERING ANGLE SENSOR  (See REMOVAL )
  9. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY  (See REMOVAL )
  10. REMOVE HEADLIGHT DIMMER SWITCH ASSEMBLY 
    1. Disconnect the connector.
    2. Disengage the clamp and claw as shown in the illustration.
      Fig 1: Identifying Clamp And Claw
      G05832312Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the headlight dimmer switch assembly as shown in the illustration.
      Fig 2: Locating Headlight Dimmer Switch Assembly
      G05832313Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals