LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> GS 350 RWD >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System >> Driver Side Knee Airbag Assembly >> Installation

Driver Side Knee Airbag Assembly: Installation

  1. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY 
    1. Connect the connector.
      NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.
    2. Install the driver side knee airbag assembly with the 4 bolts.

      Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

      Fig 1: Locating Driver Side Knee Airbag Assembly Bolts
      G05298311Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL INSTRUMENT PANEL SAFETY NO.1 PAD SUB-ASSEMBLY  (See INSTALLATION )
  3. INSTALL INSTRUMENT PANEL UNDER NO.1 COVER SUB-ASSEMBLY  (See INSTALLATION )
  4. INSTALL INSTRUMENT SIDE PANEL  (See INSTALLATION )
  5. INSTALL INSTRUMENT PANEL FINISH PANEL END  (See INSTALLATION )
  6. INSTALL FRONT ASH RECEPTACLE ASSEMBLY  (See INSTALLATION )
  7. INSTALL CONSOLE UPPER PANEL GARNISH FRONT  (See INSTALLATION )
  8. INSTALL FRONT DOOR OPENING TRIM COVER  (See INSTALLATION )
  9. INSTALL FRONT DOOR SCUFF PLATE  (See INSTALLATION )
  10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  11. PERFORM INITIALIZATION 
  12. INSPECT SRS WARNING LIGHT 
scientia non olet · About LEMON Manuals