LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2007 >> RX 400h AWD >> Repair and Diagnosis >> Hybrid/Electric Powertrain >> Testing and Diagnosis >> Hybrid Vehicle Control (P310) - RX400H - Inverter With Converter, Vehicle Control Ecu, Water Pump With Motor, Sub Radiator, Frame Wire, Accelerator Pedal Rod, Front/Rear Circuit Breaker Sensors, IGCT Relay >> Rear Circuit Breaker Sensor >> Removal

Rear Circuit Breaker Sensor: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  2. REMOVE DECK BOARD SUB-ASSEMBLY  (See REMOVAL )
  3. REMOVE DECK FLOOR BOX REAR  (See REMOVAL )
  4. REMOVE REAR FLOOR FINISH PLATE  (See REMOVAL )
  5. REMOVE DECK FLOOR BOX FRONT  (See REMOVAL )
  6. REMOVE DECK BOARD SUB-ASSEMBLY NO.2  (See REMOVAL )
  7. REMOVE DECK BOARD SUB-ASSEMBLY NO.3  (See REMOVAL )
  8. REMOVE DECK SIDE TRIM BOX RH 
  9. REMOVE DECK SIDE TRIM BOX LH  (See REMOVAL )
  10. REMOVE REAR CIRCUIT BREAKER SENSOR 
    1. Remove the rear circuit breaker sensor (LH).
      1. Move the outer section to the wire harness side as illustrated, then disconnect the rear circuit breaker sensor (LH).
        Fig 1: Disconnecting Rear Circuit Breaker Sensor (LH)
        G05278988Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      2. Remove the 2 bolts and rear circuit breaker sensor (LH).
      Fig 2: Locating Rear Circuit Breaker Sensor (LH) Bolts
      G05278989Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the rear circuit breaker sensor (RH).
      1. Move the outer section to the wire harness side as illustrated, then disconnect the rear circuit breaker sensor (RH).
        Fig 3: Disconnecting Rear Circuit Breaker Sensor (RH)
        G05278990Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      2. Remove the 2 bolts and rear circuit breaker sensor (RH).
      Fig 4: Locating Rear Circuit Breaker Sensor (RH) Bolts
      G05278991Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals