Front Passenger Airbag Assembly: Installation

INSTALL FRONT PASSENGER AIRBAG ASSEMBLY
1. Connect the 2 connectors and the 2 clamps to the front passenger airbag assembly.
  NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.
  
  Fig 1: Identifying Airbag Wire Harness
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Engage the 5 hooks (A).
3. Engage the 5 hooks (B) and install the front passenger airbag assembly on the instrument panel.
  
  Fig 2: Identifying Front Passenger Airbag Assembly Hook (B)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Install the 2 screws.
INSTALL SIDE DEFROSTER NOZZLE NO.2 DUCT (See INSTALLATION )
INSTALL HEATER TO REGISTER NO.3 DUCT (See INSTALLATION )
INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
HINT:

Refer to the procedures from "INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY" (See INSTALLATION ).

Fig 3: Identifying Front Passenger Airbag Assembly Screws
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT INSTRUMENT PANEL WIRE ASSEMBLY
1. Connect the connector.
INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY (See INSTALLATION )
INSTALL FRONT PASSENGER AIRBAG ASSEMBLY (See INSTALLATION )
INSTALL NO.2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (See INSTALLATION )
INSTALL INSTRUMENT SIDE PANEL RH (See INSTALLATION )

Fig 4: Identifying Instrument Panel Wire Assembly Connector
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT DOOR OPENING TRIM COVER RH (See INSTALLATION )
INSTALL FRONT DOOR SCUFF PLATE (w/ Illumination)
INSTALL FRONT DOOR SCUFF PLATE (w/o Illumination)
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
1. Perform initialization (See INITIALIZATION ).
  HINT:
  
  Some systems need initialization after reconnecting the cable to the negative battery terminal.
INSPECT SRS WARNING LIGHT
1. Inspect the SRS warning light (See DIAGNOSIS SYSTEM ).