Front Passenger Side Knee Airbag Assembly: Installation

INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY
1. Connect the connector.
  NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.
2. Install the front passenger side knee airbag assembly with the 3 bolts.
  Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
  
  Fig 1: Identifying Front Passenger Side Knee Airbag Assembly Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (See INSTALLATION )
INSTALL INSTRUMENT SIDE PANEL (See INSTALLATION )
INSTALL FRONT DOOR OPENING TRIM COVER (See INSTALLATION )
INSTALL FRONT DOOR SCUFF PLATE (w/ Illumination)
INSTALL FRONT DOOR SCUFF PLATE (w/o Illumination)
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
1. Perform initialization (See INITIALIZATION ).
  HINT:
  
  Some systems need initialization after reconnecting the cable to the negative battery terminal.
INSPECT SRS WARNING LIGHT
1. Inspect the SRS warning light (See DIAGNOSIS SYSTEM ).