Front Passenger Side Knee Airbag Assembly: Installation
- INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY
- Connect the connector.NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.
- Install the front passenger side knee airbag assembly with the 3 bolts.
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
- Connect the connector.
- INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (See INSTALLATION )
- INSTALL INSTRUMENT SIDE PANEL (See INSTALLATION )
- INSTALL INSTRUMENT PANEL FINISH PANEL END (See INSTALLATION )
- INSTALL FRONT ASH RECEPTACLE ASSEMBLY
- INSTALL FRONT CONSOLE UPPER PANEL GARNISH (See INSTALLATION )
- INSTALL FRONT DOOR OPENING TRIM COVER (See INSTALLATION )
- INSTALL FRONT DOOR SCUFF PLATE (See INSTALLATION )
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
- PERFORM INITIALIZATION
- Perform initialization (see INITIALIZATION (2006/02-2006/07) ).
NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal. - CHECK SRS WARNING LIGHT
- Check the SRS warning light (see DIAGNOSIS SYSTEM (2006/02-2006/07) ).