LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2006 >> RX 400h FWD >> Repair and Diagnosis >> Accessories & Equipment >> Infotainment >> Navigation >> Navigation Ecu >> Removal

Navigation Ecu: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  2. REMOVE DECK BOARD SUB-ASSEMBLY (See  REMOVAL  ) 
  3. REMOVE TONNEAU COVER ASSEMBLY 
  4. REMOVE JACK CARRIER SUPPORT 
  5. REMOVE JACK ASSEMBLY 
  6. REMOVE JACK CARRIER ASSEMBLY 
  7. REMOVE DECK FLOOR BOX FRONT (See  REMOVAL  ) 
  8. REMOVE DECK FLOOR BOX REAR (See  REMOVAL  ) 
  9. REMOVE DECK NO.2 BOARD SUB-ASSEMBLY (See ) 
  10. REMOVE DECK NO.3 BOARD SUB-ASSEMBLY (See  REMOVAL  ) 
  11. REMOVE REAR FLOOR FINISH PLATE (See  REMOVAL  ) 
  12. REMOVE DECK SIDE TRIM LH BOX (See  REMOVAL  ) 
  13. REMOVE DECK SIDE TRIM RH BOX 
  14. REMOVE NAVIGATION ECU 
    1. Disengage the clamp and disconnect the 3 connectors.
    2. Remove the 3 bolts and the navigation ECU.
      Fig 1: Identifying Bolts And Navigation ECU
      G04115931Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  15. REMOVE DISC PLAYER BRACKET 
    1. Remove the screw and the disc player bracket.
      Fig 2: Identifying Screw And Disc Player Bracket
      G04115932Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  16. REMOVE NO.2 DISC PLAYER BRACKET 
    1. Remove the 2 screws and the No.2 disc player bracket.
      Fig 3: Identifying Screws And No.2 Disc Player Bracket
      G04115933Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals