Transmission Wire: Installation

1. Coat a new O-ring with ATF and install it to the transmission wire.
   Fig 1: Identifying O-Ring With ATF

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the transmission wire with the bolt.

   Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

3. Connect the transmission wire connector.
   Fig 2: Locating Internal Wiring Harness Mounting Bolt

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Connect the 9 connectors to the solenoid valves.
   Fig 3: Identifying Solenoid Valves Connectors

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the ATF temperature sensor with the bolt.

   Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

   Fig 4: Identifying ATF Temperature Sensor With Bolt

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the 2 clamps with the 2 bolts.

   Torque: Bolt A 

   6.4 N*m (65 kgf*cm, 57 in.*lbf) 

   Bolt B 

   10 N*m (102 kgf*cm, 7 ft.*lbf) 

Fig 5: Identifying Clamps With 2 Bolts

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Coat a new O-ring with ATF.
2. Install the O-ring.
   Fig 6: Identifying O-Ring

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the oil strainer with the 4 bolts.

   Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

   Fig 7: Oil Strainer With mounting Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Install the 3 magnets in the oil pan.
   Fig 8: Identifying Magnets In Oil Pan

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install a new gasket and the oil pan to the transmission case with the 20 bolts.

   Torque: 4.4 N*m (45 kgf*cm, 39 in.*lbf) 

Fig 9: Identifying Bolts, Oil Pan And Gasket

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

(See ADJUSTMENT  )

(See INITIALIZATION  )