LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2006 >> IS 250 RWD, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Automatic Transmission (A960E)) >> Torque Converter And Drive Plate >> Installation

Torque Converter And Drive Plate: Installation

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL TORQUE CONVERTER CLUTCH ASSEMBLY (See  INSTALLATION   ) 
  2. INSTALL TRANSMISSION OIL COOLER (See  INSTALLATION   ) 
  3. INSTALL TRANSMISSION CONTROL SHAFT LEVER RH (See  INSTALLATION   ) 
  4. INSTALL REAR NO. 1 ENGINE MOUNTING INSULATOR (See  INSTALLATION   ) 
  5. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY (See  INSTALLATION   ) 
  6. INSTALL WATER BY-PASS HOSE (See  INSTALLATION   ) 7. INSTALL WIRE HARNESS (See  INSTALLATION   ) 
  7. INSTALL CONNECTOR (See  INSTALLATION   ) 
  8. INSTALL ENGINE REAR MOUNTING MEMBER (See  INSTALLATION   ) 
  9. INSTALL FLOOR SHIFT GEAR SHIFTING ROD SUBASSEMBLY (See  INSTALLATION   ) 
  10. INSTALL NO. 1 EXHAUST PIPE SUPPORT BRACKET SUB-ASSEMBLY (See  INSTALLATION   ) 
  11. INSTALL DRIVE PLATE & TORQUE CONVERTER CLUTCH SETTING BOLT (See  INSTALLATION   ) 
  12. INSTALL STARTER ASSEMBLY (See  INSTALLATION  ) 
  13. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY LH (See  INSTALLATION  ) 
  14. INSTALL PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY (See  INSTALLATION  ) 
  15. INSTALL OUTSIDE AIR GUIDE PLATE RH (See  INSTALLATION  ) 
  16. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  17. ADJUST SHIFT LEVER POSITION (See  ADJUSTMENT   ) 
  18. INSPECT SHIFT LEVER POSITION (See  ON-VEHICLE INSPECTION   ) 
  19. INSTALL FRONT FLOOR NO. 1 HEAT INSULATOR (See  INSTALLATION  ) 
  20. INSTALL FRONT EXHAUST PIPE ASSEMBLY (See  INSTALLATION  ) 
  21. INSTALL OXYGEN SENSOR (See  INSTALLATION  ) 
  22. INSTALL FRONT CENTER FLOOR BRACE (See  INSTALLATION  ) 
  23. INSTALL NO. 1 REAR FLOOR PANEL BRACE (See  INSTALLATION  ) 
  24. ADD COOLANT 

    (See COOLANT )

  25. ADD AUTOMATIC TRANSMISSION FLUID 

    (See ADJUSTMENT  )

  26. ADJUST COOLANT 

    (See COOLANT )

  27. CHECK FOR ENGINE COOLANT LEAKS (See  COOLANT  ) 
  28. CHECK FOR EXHAUST GAS LEAKS (See  INSTALLATION  ) 
  29. INSTALL NO. 2 ENGINE UNDER COVER 
  30. INSTALL ENGINE UNDER COVER 
  31. INSTALL ENGINE ROOM SIDE COVER LH (See  INSTALLATION  ) 
  32. INSTALL COOL AIR INTAKE DUCT SEAL (See  INSTALLATION  ) 
  33. RESET MEMORY 

    (See INITIALIZATION  )

  34. PERFORM INITIALIZATION 

    Some systems need initialization after reconnecting the cable to the negative battery terminal

    (See INITIALIZATION ).

Fig 1: Identifying One-Way Clutch
G04045981Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals