Park / Neutral Position Switch: Installation

WARNING: This page is about a different variant/trim than selected.

INSTALL NEUTRAL START SWITCH ASSEMBLY
1. Install the park/neutral position switch to the manual valve shaft.
2. Temporarily install the bolt.
  
  Fig 1: Identifying Park/Neutral Position Switch Mounting Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install a new lock washer and the nut.
  Torque: 6.9 N*m (70 kgf*cm, 61 in.*lbf)
  
  Fig 2: Identifying New Lock Washer And Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Temporarily install the control shaft lever.
  
  Fig 3: Identifying Control Shaft Lever
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Turn the control shaft lever counterclockwise until it stops, and turn it clockwise 2 notches to set it to the N position.
  
  Fig 4: Turning Control Shaft Lever Counterclockwise
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. Remove the transmission control shaft lever.
  
  Fig 5: Identifying Transmission Control Shaft Lever
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
7. Align the neutral alignment mark line with the switch groove, and tighten the adjusting bolt.
  Torque: 13 N*m (130 kgf*cm, 9 ft.*lbf)
  
  Fig 6: Aligning Neutral Alignment Mark Line With Switch Groove
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
8. Using a screwdriver, bend the tabs of the lock washer.
  
  Fig 7: Bending Tabs Of Lock Washer
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
9. Install the transmission control shaft lever RH with the nut.
  Torque: 16 N*m (163 kgf*cm, 12 ft.*lbf)
  
  Fig 8: Identifying Transmission Control Shaft Lever RH With Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
10. Connect the park/neutral position switch connector.
INSTALL FLOOR SHIFT GEAR SHIFTING ROD SUBASSEMBLY (See INSTALLATION )
ADJUST SHIFT LEVER POSITION (See ADJUSTMENT )

Fig 9: Identifying Park/Neutral Position Switch Connector
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSPECT SHIFT LEVER POSITION (See ON-VEHICLE INSPECTION )
INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY (See INSPECTION )