Extension Housing Rear Oil Seal: Installation

WARNING: This page is about a different variant/trim than selected.

INSTALL AUTOMATIC TRANSMISSION EXTENSION HOUSING OIL SEAL
1. Coat the lip of a new oil seal with MP grease.
2. Using SST and a hammer, drive in a new oil seal.
  SST 09325-40010
  
  Oil seal drive in depth:
  
  5.4 to 5.8 mm (0.213 to 0.228 in.)
  
  Fig 1: Identifying Oil Seal
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  NOTE:
  - Keep the lip free from foreign matter.
  - Do not tap the oil seal at an angle.
INSTALL PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY (See INSTALLATION )
REMOVE OUTSIDE AIR GUIDE PLATE RH (See REMOVAL )
INSTALL FRONT FLOOR NO. 1 HEAT INSULATOR (See INSTALLATION )
INSTALL FRONT EXHAUST PIPE ASSEMBLY (See INSTALLATION )
INSTALL FRONT CENTER FLOOR BRACE (See INSTALLATION )
INSTALL NO. 1 REAR FLOOR PANEL BRACE (See INSTALLATION )
ADD AUTOMATIC TRANSMISSION FLUID
(See ADJUSTMENT )
CHECK FOR EXHAUST GAS LEAKS (See INSTALLATION )