Valve Body Assembly: Installation

1. INSTALL TRANSMISSION VALVE BODY ASSEMBLY 
   1. Install the check ball body and spring.
      NOTE: Do not drop the check ball body and spring.
      Fig 1: Installing Check Ball Body & Spring

      Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
   2. Check the accumulator piston, check ball body and spring.
      Fig 2: Checking Accumulator Piston, Ball Body & Spring

      Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
   3. Align the groove of the manual valve with the pin of the lever.
      Fig 3: Aligning Groove Of Manual Valve With Pin Of Lever

      Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
   4. Install the 20 bolts.

   Torque: 11 N*m (112 kgf*cm, 8 ft.*lbf) 

   Bolt length: 

   Bolt A: 36 mm (1.42 in.) 

   Bolt B: 25 mm (0.98 in.) 

   Bolt C: 45 mm (1.77 in.) 

   Bolt D: 50 mm (1.97 in.) 

   Fig 4: Installing Transmission Valve Body Assembly Bolts

   Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
2. CONNECT TRANSMISSION WIRE (See step 2 in  INSTALLATION   ) 
3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY (See step 3 in  INSTALLATION   ) 
4. INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY (See step 4 in  INSTALLATION   ) 
5. INSTALL NO. 1 EXHAUST PIPE SUPPORT BRACKET SUB-ASSEMBLY (See step 12 in  INSTALLATION   ) 
6. ADD AUTOMATIC TRANSMISSION FLUID 

   (See step 3 in ADJUSTMENT  )

7. RESET MEMORY 

(See INITIALIZATION  )