Transmission Wire: Installation

1. INSTALL TRANSMISSION WIRE 
   1. Coat a new O-ring of the transmission wire connector with ATF.
   2. Install the O-ring.
      Fig 1: Identifying Transmission Wire Harness O-Ring

      Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
   3. Install the transmission wire with the bolt.

      Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

   4. Connect the transmission wire connector.
   Fig 2: Identifying Internal Wiring Harness Mounting Bolt

   Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
2. CONNECT TRANSMISSION WIRE 
   1. Connect the 9 connectors to the solenoid valves.
      Fig 3: Locating Electrical Connectors

      Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
   2. Install the 2 clamps with the 2 bolts.

      Torque: Bolt A 

      6.4 N*m (65 kgf*cm, 57 in.*lbf) 

      Torque: Bolt B 

      10 N*m (102 kgf*cm, 7 ft.*lbf) 

      Fig 4: Installing Clamps With Bolts

      Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
   3. Install the ATF temperature sensor with the bolt.

      Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

   Fig 5: Locating ATF Temperature Sensor Locking Plate Bolt

   Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY 
   1. Coat a new O-ring with ATF and install it to the oil strainer.
      Fig 6: Installing O-Ring With ATF To Oil Strainer

      Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
   2. Install the oil strainer with the 4 bolts.

   Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

   Fig 7: Installing Oil Strainer With Mounting Bolts

   Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
4. INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY 
   1. Install the 6 magnets in the oil pan.
      Fig 8: Installing Magnets In Oil Pan

      Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
   2. Install a new gasket and the oil pan with the 20 bolts to the transmission case.

   Torque: 4.4 N*m (45 kgf*cm, 39 in.*lbf) 

   Fig 9: Identifying Oil Pan Bolts

   Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
5. INSTALL NO. 1 EXHAUST PIPE SUPPORT BRACKET SUB-ASSEMBLY (See step 12 in  INSTALLATION   ) 
6. ADD AUTOMATIC TRANSMISSION FLUID 

   (See step 3 in ADJUSTMENT  )

7. RESET MEMORY 

(See INITIALIZATION  )