LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2006 >> IS 250 RWD, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission (A760H)) >> Torque Converter And Drive Plate >> Removal

Torque Converter And Drive Plate: Removal

WARNING: This page is about a different variant/trim than selected.
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  2. REMOVE COOL AIR INTAKE DUCT SEAL (See  REMOVAL  ) 
  3. REMOVE ENGINE ROOM SIDE COVER LH (See step 2 in  REMOVAL  ) 
  4. REMOVE ENGINE UNDER COVER 
  5. DRAIN COOLANT (See step 4 in  ON-VEHICLE INSPECTION  ) 
  6. DRAIN AUTOMATIC TRANSMISSION FLUID (See step 6 in  REMOVAL   ) 
  7. REMOVE NO. 1 REAR FLOOR PANEL BRACE (See  REMOVAL  ) 
  8. REMOVE FRONT CENTER FLOOR BRACE (See step 2 in  REMOVAL  ) 
  9. REMOVE OXYGEN SENSOR (See  REMOVAL  ) 
  10. REMOVE FRONT EXHAUST PIPE ASSEMBLY (See step 5 in  REMOVAL  ) 
  11. REMOVE FRONT FLOOR NO. 1 HEAT INSULATOR (See step 2 in  REMOVAL  ) 
  12. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH (See step 11 in  REMOVAL  ) 
  13. REMOVE STARTER ASSEMBLY (See step 12 in  REMOVAL  ) 
  14. REMOVE FRONT PROPELLER SHAFT ASSEMBLY (See step 2 in  REMOVAL  ) 
  15. REMOVE OUTSIDE AIR GUIDE PLATE RH (See step 3 in  REMOVAL  ) 
  16. REMOVE PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY (See step 4 in  REMOVAL  ) 
  17. REMOVE FLYWHEEL HOUSING SIDE COVER (See step 17 in  REMOVAL   ) 
  18. REMOVE DRIVE PLATE & TORQUE CONVERTER CLUTCH SETTING BOLT (See step 18 in  REMOVAL   ) 
  19. REMOVE NO. 1 EXHAUST PIPE SUPPORT BRACKET SUB-ASSEMBLY (See step 19 in  REMOVAL   ) 
  20. SEPARATE FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY (See step 20 in  REMOVAL   ) 
  21. SUPPORT AUTOMATIC TRANSMISSION WITH TRANSFER ASSEMBLY (See step 21 in  REMOVAL   ) 
  22. SEPARATE ENGINE REAR MOUNTING MEMBER (See step 22 in  REMOVAL   ) 
  23. SEPARATE CONNECTOR (See step 23 in  REMOVAL   ) 
  24. SEPARATE WIRE HARNESS (See step 24 in  REMOVAL   ) 
  25. SEPARATE WATER BY-PASS HOSE (See step 25 in  REMOVAL   ) 
  26. REMOVE AUTOMATIC TRANSMISSION WITH TRANSFER ASSEMBLY (See step 26 in  REMOVAL   ) 
  27. REMOVE ENGINE REAR MOUNTING MEMBER (See step 27 in  REMOVAL   ) 
  28. REMOVE REAR NO. 1 ENGINE MOUNTING INSULATOR (See step 28 in  REMOVAL   ) 
  29. REMOVE TRANSFER DYNAMIC DAMPER (See step 29 in  REMOVAL   ) 
  30. REMOVE TRANSMISSION CONTROL SHAFT LEVER LH (See step 30 in  REMOVAL   ) 
  31. REMOVE TRANSMISSION OIL COOLER (See step 31 in  REMOVAL   ) 
  32. REMOVE TORQUE CONVERTER CLUTCH ASSEMBLY (See step 32 in  REMOVAL   ) 
  33. INSPECT TORQUE CONVERTER CLUTCH ASSEMBLY (See  INSPECTION   ) 
scientia non olet · About LEMON Manuals