Fuel Pressure Sensor: Removal
WARNING: This page is about a different car, the 2006 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.
- REMOVE COOL AIR INTAKE DUCT SEAL (See REMOVAL )
- REMOVE ENGINE ROOM SIDE COVER LH (See REMOVAL )
- REMOVE ENGINE ROOM SIDE COVER RH (See REMOVAL )
- REMOVE V-BANK COVER SUB-ASSEMBLY (See REMOVAL )
- REMOVE FRONT UPPER FENDER PROTECTOR LH (See REMOVAL )
- REMOVE FRONT UPPER FENDER PROTECTOR RH
HINT:
Removal procedure of the RH side is the same as that of the LH side.
- REMOVE ROOF DRIP SIDE FINISH MOULDING LH (See REMOVAL )
- REMOVE ROOF DRIP SIDE FINISH MOULDING RH
HINT:
Removal procedure of the RH side is the same as that of the LH side.
- REMOVE FRONT WIPER ARM HEAD CAP (See REMOVAL )
- REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH (See REMOVAL )
- REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH (See REMOVAL )
- REMOVE COWL TOP VENTILATOR LOUVER SUBASSEMBLY (See INSTALLATION )
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
- DISCHARGE FUEL SYSTEM PRESSURE
HINT:
See FUEL SYSTEM .
- DRAIN ENGINE COOLANT (See COOLANT )
- DISCONNECT NO. 2 VENTILATION HOSE (See REMOVAL )
- REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE ASSEMBLY (See REMOVAL )
- REMOVE THROTTLE WITH MOTOR BODY ASSEMBLY (See REMOVAL )
- REMOVE INTAKE AIR SURGE TANK (See REMOVAL )
- REMOVE INTAKE MANIFOLD (See REMOVAL )
- DISCONNECT WATER HOSE JOINT (See REMOVAL )
- REMOVE NO. 1 FUEL PIPE (See REMOVAL )
- REMOVE FUEL PRESSURE SENSOR
- Disconnect the connector and clamp.
- Remove the fuel pressure sensor and gasket.