LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2006 >> IS 250 RWD, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Engine Control System (2GR-FSE)) >> Crankshaft Position Sensor >> Removal

Crankshaft Position Sensor: Removal

WARNING: This page is about a different car, the 2006 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE COOL AIR INTAKE DUCT SEAL (See  REMOVAL  ) 
  2. REMOVE V-BANK COVER SUB-ASSEMBLY (See  REMOVAL  ) 
  3. REMOVE NO. 1 INLET AIR CLEANER (See  REMOVAL  ) 
  4. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM (See  REMOVAL  ) 
  5. REMOVE V-RIBBED BELT (See  REMOVAL  ) 
  6. REMOVE ENGINE UNDER COVER 
  7. REMOVE REAR ENGINE UNDER COVER LH 
  8. DISCONNECT NO. 1 COOLER REFRIGERANT SUCTION HOSE (See  REMOVAL  ) 
  9. DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY (See  REMOVAL  ) 
  10. REMOVE COMPRESSOR WITH PULLEY ASSEMBLY (See  REMOVAL  ) 
  11. REMOVE CRANKSHAFT POSITION SENSOR 
    1. Disconnect the crankshaft position sensor connector.
    2. Remove the bolt and crankshaft position sensor.
      Fig 1: Identifying Crankshaft Position Sensor
      G04054943Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals