LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2006 >> GS 300 RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (Starting (3UZ-FE)) >> Engine Switch >> Installation

Engine Switch: Installation

WARNING: This page is about a different car, the 2006 Lexus GS 430. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL ENGINE SWITCH 
    1. Attach the 2 claws and install the switch.
    2. Connect the switch connector.
  2. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY (See  REMOVAL  ) 
  3. INSTALL INSTRUMENT PANEL NO. 1 UNDER COVER SUB-ASSEMBLY (See  INSTALLATION  ) 
  4. INSTALL INSTRUMENT PANEL NO. 1 SAFETY PAD SUB-ASSEMBLY (See  INSTALLATION  ) 
    Fig 1: Identifying Engine Switch
    G04028143Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. INSTALL INSTRUMENT SIDE PANEL LH (See  INSTALLATION  ) 
  6. INSTALL FRONT DOOR OPENING TRIM COVER LH (See  INSTALLATION  ) 
  7. INSTALL FRONT DOOR SCUFF PLATE LH (See  INSTALLATION  ) 
  8. INSTALL INSTRUMENT PANEL FINISH PANEL END LH (See  INSTALLATION  ) 
  9. INSTALL FRONT CONSOLE UPPER PANEL ASSEMBLY ( INSTALLATION  ) 
  10. INSTALL FRONT CONSOLE UPPER PANEL GARNISH ( INSTALLATION  ) 
  11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  12. PERFORM INITIALIZATION 
    1. Perform initialization (INITIALIZATION ).
      NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
  13. CHECK SRS WARNING LIGHT 
    1. Check the SRS warning light (DIAGNOSIS SYSTEM ).
scientia non olet · About LEMON Manuals