Rear Brake Caliper: Removal

Torque: 103 N.m (1,050 kgf.cm, 76 ft.lbf) 

Remove the union bolt and gasket from the caliper, then disconnect the flexible hose from the caliper. Use a container to catch brake fluid as it drains out.

Torque: 30 N.m (310 kgf.cm, 22 ft.lbf) 

HINT:

At the time of installation, please refer to the following item. Install the flexible hose lock securely in the lock hole in the caliper.

Fig 1: Disconnecting Flexible Hose From Caliper

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Remove the 2 installation bolts.

   Torque: 104 N.m (1,065 kgf.cm, 77 ft.lbf) 

2. Remove the caliper.

1. Remove the anti-squeal spring.
2. Remove the clip and pad guide pin.
3. Remove the 2 pads with the 4 anti-squeal shims.