DTC P010A-09: Mass or Volume Air Flow Sensor "B" Circuit - Component failure: Action
WARNING: This page is about a different variant/trim than selected.
- Vehicle Conditions to enable DTC
Logging Strategy
- Ignition on, start engine and idle for 30 seconds
- Prioritized Checks to Perform
- Using the Jaguar Land Rover approved diagnostic equipment check datalogger signal
- Mass Air Flow Sensor (0xF466)
- Inspect TMAF B connectors for signs of water ingress, and pins for damage and/or corrosion
- Refer to the electrical circuit diagrams and check TMAF B circuit for short circuit to ground, short circuit to power, open circuit, high resistance
- I_F_AMS2 and G_R_AMS2 are not generating any signal frequency at around 1.05kHz