DTC P0106-62: Manifold Absolute Pressure/Barometric Pressure Sensor Circuit Range/Performance - Signal compare failure: Action
WARNING: This page is about a different variant/trim than selected.
- Vehicle Conditions to enable DTC
Logging Strategy
- Start engine and bring to normal operating temperature. Drive vehicle steadily between 1000 and 4500 RPM; hold steady throttle and engine speed for 20 seconds. Alternatively, rev engine in Park to 2000RPM fully warm and hold for 20 second
- Prioritized Checks to Perform
- Using the Jaguar Land Rover approved diagnostic equipment check datalogger signal
- Manifold Absolute Pressure - High Resolution (0x0370)
- Refer to the electrical circuit diagrams and check the intake manifold TMAP sensor (manifold pressure) circuit for short circuit to ground, short circuit to power, open circuit, high resistance
- Inspect connectors for signs of water ingress, and pins for damage and/or corrosion
- Install new intake manifold TMAP sensor (manifold pressure), only when diagnosed as failed
- Check air filter is serviceable
- Check intake manifold for air leak (loose or missing component)
- Check breather system for leak (loose or missing component)
- Check electric throttle blade for contamination by oil or debris clean as required
- Check for damaged/restricted exhaust system
- Using the Jaguar Land Rover approved diagnostic equipment, clear all stored Diagnostic Trouble Code(s) and retest