Possible Causes
WARNING: This page is about a different variant/trim than selected.
- Electrical Cause
- Yes
- Mechanical Cause
- No
- Control Module Cavity
- Circuit reference I_A_MAP
- Monitor Description
- Pressure sensor plausibility check prior to engine start
- Component
- Intake manifold TMAP sensor (manifold pressure)
- Purpose of the DTC
- This DTC is used to determine if the manifold pressure sensor is offset low during ignition on
- Prioritized List of Possible Causes
- Intake manifold TMAP sensor (manifold pressure) circuit - Wiring integrity short circuit to ground, short circuit to power, open circuit, high resistance
- Connector is disconnected, connector pin is backed out, connector pin corrosion
- Intake manifold TMAP sensor (manifold pressure) failure