P2261-73: Turbocharger/Supercharger Bypass Valve "A" - Mechanical - Actuator stuck closed: Action

WARNING: This page is about a different variant/trim than selected.

NOTE: If a fault is identified with the wastegate system or the actuator, install a new turbocharger. The actuator is not a replaceable part. DO NOT remove the actuator or the connecting rod

Vehicle Conditions to Enable DTC Logging Strategy
- Ignition On
Inspect connectors for signs of water ingress, and pins for damage and/or corrosion
Check the powertrain control module connectors for water ingress
Refer to the electrical circuit diagrams and check the turbocharger electronic wastegate circuit for
- Short circuit to ground
- Short circuit to power
- Open circuit
- High resistance
Check turbocharger wastegate rod movement, start the engine and monitor wastegate rod movement DO NOT attempt to disconnect, manipulate or put pressure on the waste gate rod, doing so can result in damage and loss of function of waste gate actuation
Check turbocharger wastegate voltage at closed position
Check turbocharger wastegate rod/lever for any mechanical damage, bend or heavy corrosion close to pin For additional information, Refer to: TURBOCHARGER
Using the Jaguar Land Rover approved diagnostic equipment, clear the Diagnostic Trouble Code(s) and retest