- Head up display image shows a secondary image - HUD
image does not look sharp
|
- Protective film still covering HUD
lens
- Incorrect seat and HUD
display position
- Windshield damage in HUD
projection area
- HUD
windshield has not been tested by the glass manufacturer
- Non HUD
windshield installed in the vehicle
|
- Check and remove the protective film from the HUD
lens as required
- GO to PINPOINT TEST A . HUD
Image distorted - Seating position
- GO to PINPOINT TEST A . HUD
Image distorted - windshield check
- GO to PINPOINT TEST A . HUD
Image distorted - Test Result Check
- GO to PINPOINT TEST A . HUD
Image distorted - Logo and trademark check
|
- Head up display projected image brightness does not adjust
|
- Windshield covered in dirt/dust
- Incorrect rain/light sensor installed
|
- Clean the windshield
- GO to PINPOINT TEST B . HUD
Brightness - Rain/Light Sensor Check
|
- Head up display does not project image
|
- Item covering HUD
projector unit
- HUD
internal failure
|
- Remove any items covering the projector unit
- GO to PINPOINT TEST C . HUD
- Inoperative
|
- Head up display navigation display not operational
|
- Car Configuration File (CCF) or system settings require adjustment
- APIX2 circuits disconnected
- HUD
internal failure
|
|
- Head up display traffic sign recognition display not operational
|
- CCF
or system settings require adjustment
- HUD
internal failure
|
|