Pinpoint Test A: Head Up Display (HUD) Windshield Projected Image Distorted
- A1: HUD IMAGE DISTORTED
- Sitting in the drivers seat, inspect the HUD
lens at the rear of the instrument panel
Has the protective film been removed from the HUD lens?
Yes: GO to A2.
No: Check and remove the protective film from the HUD lens as required
- Sitting in the drivers seat, inspect the HUD
lens at the rear of the instrument panel
- A2: HUD IMAGE DISTORTED - SEATING POSITION NOTE: If comparing HUD displays between two vehicles you must compare the same models, for example L462 to L462
- The driver must be SITTING IN THE CORRECT POSITION (see owners manual) to view the HUD display
- When seated correctly the HUD adjustment can be made by selecting HUD Position from the Head up Display menu and follow the on-screen instructions
- With the driver sitting in the CORRECT
position and the HUD
adjusted correctly, view the HUD
projected image on the windshield
Is the HUD projected image distorted?
Yes: GO to A3.
No: Advise the customer of the correct seat and HUD position (see owners manual)
- A3: HUD IMAGE DISTORTED - WINDSHIELD CHECK
- Inspect the windshield for stone chip or crack damage, at the HUD
projection area
Has the windshield sustained any stone chip or crack damage, at the HUD projection area?
Yes: Install a new HUD windshield as required
No: GO to A4.
- Inspect the windshield for stone chip or crack damage, at the HUD
projection area
- A4: HUD IMAGE DISTORTED - LOGO AND TRADEMARK CHECK
- Look for the correct HUD
trademark on the windshield
Does the windshield have the correct HUD trademark? The symbol circled in the manufactures brand logo, is the HUD trademark and defines it as a HUD variant windshield. Depending on the model and glass manufacturer this position may change
Yes: GO to A5.
No: Incorrect windshield is installed. Install the correct HUD windshield as required
- Look for the correct HUD
trademark on the windshield
- A5: HUD IMAGE DISTORTED - TEST RESULT CHECK
- Refer to the relevant service information and remove the rear view mirror mounting bracket plastic trim
- With the rear view mirror mounting bracket plastic trim removed, the windshield manufactures test results are printed/attached to the windshield
- Pilkington print the test results on a white label and is attached it to the windshield
- The test result is the sequence number and the date/time the image was tested
Is the manufactures test results printed/attached on to the windshield?
Yes: Windshield image distorted checks now complete. The following pinpoint tests cover the rain/light sensor checks GO to PINPOINT TEST B .
No: Incorrect windshield is installed. Install the correct HUD windshield as required
- Refer to the relevant service information and remove the rear view mirror mounting bracket plastic trim