LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2021 >> Defender 110 S >> Repair and Diagnosis >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling - INGENIUM 2.0L Petrol/INGENIUM I4 2.0L Petrol - PHEV -- Defender/L663 >> Engine Cooling - INGENIUM I4 2.0L Petrol/INGENIUM I4 2.0L Petrol - PHEV (G2344342) >> Removal And Installation >> Coolant Expansion Tank (G2417622) >> Installation

Coolant Expansion Tank (G2417622): Installation

    • Connect the coolant expansion tank outlet hose.
    • Connect the electrical connector to the coolant expansion tank level sensor.
    • Remove the hose clamp from the coolant expansion tank outlet hose.
  2. Connect the 2 coolant pipes.
  3. Top up the cooling system to the 'MAX' mark.

    Refer to: SPECIFICATIONS 

    • Install the coolant expansion tank.
    • Install and tighten the bolt.

      Torque  : 2.8 Nm 

  5. CAUTION: Correct installation of the coolant expansion tank cap can be obtained by tightening the cap until three audible clicks have been heard.

    Install the coolant expansion tank filler cap.

    • Install the engine compartment front cover.
    • Install the 6 clips.
    • Install and tighten the 2 bolts.

      Torque  : 5 Nm 

scientia non olet · About LEMON Manuals