Transfer Case - TDV8 4.4L Diesel (G1966998): Part(S)
| STEP | PART NAME | QUANTITY |
|---|---|---|
| Step 6 | Driveshaft to front output flange bolts | 1 |
CAUTION:
- New transfer cases may be supplied with untapped bolt holes, reuse the original bolts when self tapping the new threads.
- Re-manufactured transfer cases have tapped holes, bolts must be installed finger tight before applying Torque.
NOTE:
- Some variation in the illustrations may occur, but the essential information is always correct.
- Component shown removed for clarity.
- Disconnect the battery ground cable.
Refer to: SPECIFICATIONS
-
WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
- Refer to: TRANSMISSION SUPPORT CROSSMEMBER - TDV8 4.4L DIESEL
- Refer to: REAR DRIVESHAFT - TDV6 3.0L DIESEL/TDV6 3.0L DIESEL - GEN 1.5/TDV6 3.0L DIESEL - GEN 2
-
CAUTION: Air tools must not be used.
-
CAUTION:
- Mark the position of the driveshaft flange in relation to the drive pinion flange.
- To avoid damage to the joint or gaiter, do not allow the driveshaft to hang.
- Discard the bolts.
Renew Part: Driveshaft to front output flange bolts Quantity: 1.
-
CAUTION: Air tools must not be used.
Remove the ground cable.
-
CAUTION: Air tools must not be used.
Vehicles with diesel particulate filter (DPF).
-
CAUTION: Air tools must not be used.
Vehicles without diesel particulate filter (DPF).
-
CAUTION: Always plug any open connections to prevent contamination.
-
CAUTION: Air tools must not be used.
Remove the transfer case damper.
Using a suitable stand, support the transfer case.
Special Tool(s): 303-1069
-
CAUTION: Do not carry out this step if a new transfer box is to be installed.