General Equipment
| EQUIPMENT NAME |
|---|
| Transmission jack |
- Some variation in the illustrations may occur, but the essential information is always correct.
- Some illustrations may show the transmission removed for clarity.
The following step(s) applies to:
All vehicles
-
Refer to: SPECIFICATIONS
-
Refer to: SECONDARY BULKHEAD CENTER PANEL
-
WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
- Secure with 2 cable ties.
-
NOTE: Using a suitable transmission jack support the differential case.
- General Equipment: Transmission jack
-
Refer to: EXHAUST SYSTEM
-
Refer to: FRONT DRIVESHAFT - V6 S/C 3.0L PETROL/V8 S/C 5.0L PETROL
-
Refer to: REAR DRIVESHAFT - V6 S/C 3.0L PETROL/V8 S/C 5.0L PETROL
The following step(s) applies to:
Vehicles with single speed transfer case
The following step(s) applies to:
Vehicles with twin speed transfer case
The following step(s) applies to:
All vehicles
-
CAUTION:
- Be prepared to collect escaping fluids.
- Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed.
NOTE: Remove and discard the O-ring seals. -
CAUTION:
- Only rotate the crankshaft clockwise.
- Discard the bolts.
-
WARNING: Make sure that the transmission is secured with suitable retaining straps.
Lower the rear of the transmission for access.
-
NOTE: Secure with cable ties.
-
NOTE: Secure with cable ties.
-
NOTE: Secure with cable ties.
-
NOTE: Secure with cable ties.
-
NOTE: Note the position of the bolts prior to removal.
-
NOTE: Note the position of the bolts prior to removal.
-
WARNING: This step requires the aid of another technician.CAUTION: Make sure that the torque converter remains in the transmission.NOTE: Secure the torque converter to the transmission using suitable cable ties.
-
NOTE: Do not disassemble further if the component is removed for access only.
-
CAUTION: Always plug any open connections to prevent contamination.
The following step(s) applies to:
Vehicles with twin speed transfer case
The following step(s) applies to:
Vehicles with single speed transfer case
The following step(s) applies to:
All vehicles
Special Tool(s): 303-1069