LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2019 >> Range Rover Sport Supercharged Dynamic >> Repair and Diagnosis >> Engine Mechanical >> Exhaust System - V8 S/C 5.0L Petrol -- Range Rover Sport/L494 >> Exhaust System - V8 S/C 5.0L Petrol (G1509419) >> Removal And Installation >> Right Catalytic Converter (G2286584) >> Installation

Right Catalytic Converter (G2286584): Installation

  1. NOTE: Only complete step 1 - 2 if the components were previously removed.
    • Install the mass damper.
    • Install and tighten the bolt.

      Torque  : 23.5 Nm 

  2. CAUTION:
    • Make sure the anti-seize compound does not contact the HO2S  tip.
    • If accidentally dropped or knocked install a new HO2S  .
    • Make sure the HO2S  wiring harness is not twisted, or damaged and is not in contact with either the exhaust or driveshaft.
    NOTE: If the original HO2S  is to be installed, apply lubricant meeting specification ESE-M12A4-A to the thread of the HO2S  .
    • Using the special tool, install and tighten the 2 HO2S  .

      Special Tool(s): JLR-303-1666 

      Torque  : 48 Nm 

  3. NOTE: Make sure the component is installed to the noted position.
    • Install the left catalytic converter.
    • Install and tighten the exhaust clamp nut.

      Torque  : 55 Nm 

  4. Install the exhaust system.

    Refer to: EXHAUST SYSTEM 

  5. Connect the startup battery ground cable.

    Refer to: SPECIFICATIONS

scientia non olet · About LEMON Manuals