FLEXPLATE (G2131637): Installation
WARNING: This page is about a different variant/trim than selected.
- Using a suitable tool, clean out the threads.
- CAUTION:
- Install all the bolts finger tight before final tightening.
- Make sure that all the component mating faces are clean.
Tighten the retaining bolts working diagonally, install new bolts.
Renew Part: Flexplate bolts Quantity: 1 .
Torque
Stage 1: 45 Nm
Stage 2: 90°
- Remove the special tool.
Special Tool(s): 303-1123
- Install the transmission.
Refer to: TRANSMISSION - TDV6 3.0L DIESEL
- Connect the battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT