Crankshaft Rear Seal (G2033435): Removal
WARNING: This page is about a different variant/trim than selected.
NOTE:
- This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
- This procedure contains illustrations showing certain components removed to provide extra clarity.
- Disconnect the startup battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT
- Raise and support the vehicle on a suitable 2 post lift.
Refer to: LIFTING
- Remove the Crankshaft Position (CKP) sensor ring.
Refer to: CRANKSHAFT POSITION SENSOR RING
- Remove the 4 bolts.
-
CAUTION: Discard the seal.
- Remove the 10 bolts.
- Remove and discard the rear crankshaft oil seal.