Camshaft Front Seal (G2033431): Installation

WARNING: This page is about a different variant/trim than selected.

CAUTION: Install a new seal.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Install the new seal on the special tool.

Special Tool(s): 303-1119
CAUTION:
- A new camshaft front seal is supplied with a transit sleeve that must not be removed until the camshaft front seal is fully installed. Failure to follow this instruction may result in damage to the vehicle.
- Do not use any lubricant on the camshaft front seal, transit sleeve or the camshaft. Failure to follow this instruction may result in damage to the vehicle.
- Make sure the seal is installed correctly.
- Make sure that the mating faces are clean and free of corrosion and foreign material.
NOTE: Make sure that the seal is 1 mm below the face of the cylinder head.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Using the special tool install the camshaft front seal.
Remove the special tool.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
Install the camshaft pulley hub.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
Install the special tool.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Special Tool(s): 303-1124
Using the special tool tighten the bolt.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Torque

Stage 1: 80 Nm

Stage 2: 80°
Remove the special tool.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
CAUTION: Only tighten the bolts finger tight at this stage.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Install the front camshaft pulley.
- Tighten the 3 bolts.
CAUTION: Do not use the special tools to lock the camshafts. Failure to follow this instruction may result in damage to the engine or the special tools.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Install the special tool.

Special Tool(s): 303-1126
Install the timing belt.
Refer to: TIMING BELT
Connect the startup battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT