Left Camshaft (G2105539): Removal
WARNING: This page is about a different variant/trim than selected.
CAUTION:
Make sure that the orientation and code on the top of the camshaft bearing caps is noted (along with the bank - A or B), so that on installation the components are installed to their original position. Failure to follow this instruction may cause damage to the vehicle.
NOTE:
- This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
- This procedure contains illustrations showing certain components removed to provide extra clarity.
- Disconnect the startup battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT
- Raise and support the vehicle on a suitable 2 post lift.
Refer to: LIFTING
- Remove the timing chain and drive components.
Refer to: TIMING DRIVE COMPONENTS
- Remove the valve cover.
Refer to: LEFT VALVE COVER
-
CAUTION:
- Rotate the camshafts until all the valves are at their minimum open point.
- Evenly and progressively, release the camshaft bearing caps.
NOTE: Note their position, orientation and markings. Each is marked with its position (number) and an orientation (arrow).- Remove the camshaft bearing caps.
- Remove the camshafts.