LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2018 >> Range Rover Velar Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine - V6 S/C 3.0L Petrol -- Range Rover Velar/L560) >> Engine - V6 S/C 3.0L Petrol >> Removal And Installation >> Crankshaft Front Seal (G1850999) >> Installation

Crankshaft Front Seal (G1850999): Installation

WARNING: This page is about a different variant/trim than selected.
  1. CAUTION:
    • Do not over tighten the crankshaft front seal. Failure to follow this instruction may result in damage to the vehicle.
    • Take extra care not to damage the seal.

    Using the special tool install the new front crankshaft oil seal.

    Special Tool(s): 303-1434 

    Renew Part: Crankshaft front oil seal Quantity: 1  .

  2. Install the crankshaft pulley.

    Refer to: CRANKSHAFT PULLEY 

  3. Connect the startup battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT

scientia non olet · About LEMON Manuals