LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2018 >> Range Rover Velar Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine - INGENIUM I4 2.0L Diesel -- Range Rover Velar/L560 (2 Of 2)) >> Engine - INGENIUM I4 2.0L Diesel >> Removal And Installation >> Oil Pump (G1947468) >> Installation

Oil Pump (G1947468): Installation

WARNING: This page is about a different variant/trim than selected.
  1. NOTE: Only carry out this step if previously removed.

    Install the oil pick-up pipe and tighten the bolts to the correct torque.

    Torque  : 12 Nm 

  2. Install the oil pump and tighten the bolts to the correct torque.

    Torque  : 25 Nm 

  3. Install the oil pump wiring harness.
  4. Connect the electrical connector for the oil pump.
  5. Install the oil pump chain.

    Refer to: OIL PUMP CHAIN 

  6. Connect the startup battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT

scientia non olet · About LEMON Manuals