LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2018 >> Range Rover Velar Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Cooling - TDV6 3.0L Diesel -- Range Rover Velar/L560) >> Engine Cooling - TDV6 3.0L Diesel >> Removal And Installation >> Coolant Pump (G1881153) >> Installation

Coolant Pump (G1881153): Installation

WARNING: This page is about a different variant/trim than selected.
  1. CAUTION:
    • Install a new O-ring seal.
    • Make sure that the mating faces are clean and free of foreign material.
    NOTE: Lubricate the O-ring seal with clean coolant.
    • Install the coolant pump.
    • Install the 3 bolts and tighten to the correct torque.

      Torque  : 10 Nm 

  2. Connect the electrical connector to the coolant pump assembly.
  3. Install the coolant pump pulley and tighten the 3 bolts to the correct torque.

    Torque  : 25 Nm 

  4. Install the clean air duct and tighten the clamp to the correct torque.

    Torque  : 3.5 Nm 

  5. Locate the coolant hose in the correct position.
  6. Install the left air cleaner assembly.

    Refer to: LEFT AIR CLEANER

  7. Raise the vehicle.
  8. Install the accessory drive belt.

    Refer to: ACCESSORY DRIVE BELT

  9. Fill the cooling system.

    Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING 

  10. Connect the startup battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT

scientia non olet · About LEMON Manuals