LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2018 >> Range Rover Velar Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 28 (Starting System - TDV6 3.0L Diesel -- Range Rover Velar/L560) >> Starting System - TDV6 3.0L Diesel >> Removal And Installation >> Starter Motor (G2110301) >> Installation

Starter Motor (G2110301): Installation

WARNING: This page is about a different variant/trim than selected.
  1. Connect the breathers.
  2. Install the starter motor.

    Torque  : 47 Nm 

  3. Secure the breather clip.
  4. Install the mounting bracket.

    Torque  : 25 Nm 

  5. Secure the wiring harness clips.
  6. Connect the wiring harness nut.

    Torque  : 7 Nm 

    • Connect the battery cable.

      Torque  : 12 Nm 

    • Secure the cover.
  8. Install the engine undershield.

    Refer to: ENGINE UNDERSHIELD

  9. Connect the startup battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT

scientia non olet · About LEMON Manuals