Right Fuel Rail (G1879937): Removal
WARNING: This page is about a different variant/trim than selected.
WARNING:
- Be prepared to collect escaping fuel.
- Wait for a minimum of 1 minute after the engine has stopped before carrying out any repair to the fuel injection system.
CAUTION:
- Before disconnecting or removing components, ensure the area around the joint faces and connections are clean. Plug open connections to prevent contamination.
- Make sure that the area around the component is clean and free of foreign material.
NOTE:
- This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
- This procedure contains illustrations showing certain components removed to provide extra clarity.
- Refer to: STARTUP BATTERY DISCONNECT AND CONNECT
- Refer to: ENGINE COVER - TDV6 3.0L DIESEL
- Refer to: RIGHT EXHAUST GAS RECIRCULATION VALVE
- Refer to: EXHAUST GAS RECIRCULATION VALVE OUTLET TUBE
- Refer to: FUEL INJECTION COMPONENT CLEANING
-
CAUTION: Be prepared to collect escaping fuel.
- Refer to: FUEL INJECTION COMPONENT CLEANING
-
CAUTION:
- Be prepared to collect escaping fuel.
- Discard the components.
-
CAUTION:
- Be prepared to collect escaping fuel.
- Discard the components.
-
CAUTION:
- Be prepared to collect escaping fuel.
- Discard the components.
-
CAUTION: Be prepared to collect escaping fuel.
-
CAUTION:
- Be prepared to collect escaping fuel.
- Discard the components.
-
CAUTION: Be prepared to collect escaping fuel.
-
CAUTION: Be prepared to collect escaping fuel.
-
CAUTION: Be prepared to collect escaping fuel.
-
CAUTION: Be prepared to collect escaping fuel.
-
CAUTION:
- Be prepared to collect escaping fuel.
- Discard the components.