Fuel Injection Pump (G1202330): Removal
WARNING: This page is about a different variant/trim than selected.
NOTE:
Removal steps in this procedure may contain installation details.
- Refer to: STARTUP BATTERY DISCONNECT AND CONNECT
- Refer to: ENGINE COVER - TDV6 3.0L DIESEL
-
NOTE: Left shown, right similar.
- Refer to: FUEL INJECTION COMPONENT CLEANING
- Refer to: FUEL INJECTION PUMP PULLEY
- Refer to: CRANKCASE VENT OIL SEPARATOR
-
CAUTION: Be prepared to collect escaping fuel.
-
CAUTION: Be prepared to collect escaping fuel.
-
CAUTION:
- Be prepared to collect escaping fuel.
- Discard the component.
NOTE: Some variation in the illustrations may occur, but the essential information is always correct. -
CAUTION:
- Be prepared to collect escaping fuel.
- Discard the component.
-
CAUTION:
- Be prepared to collect escaping fuel.
- Discard the component.
-
CAUTION: Be prepared to collect escaping fuel.NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
-
CAUTION: Be prepared to collect escaping fuel.NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
-
CAUTION:
- Be prepared to collect escaping fuel.
- Discard the components.
Special Tool(s): 303-1124
-
NOTE: Do not disassemble further if the component is removed for access only.