Fuel Injectors (G2155706): Installation

WARNING: This page is about a different variant/trim than selected.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Install and discard seals.

Renew Part: Fuel injector O-ring seals Quantity: 1 .
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Using the special tool, install a new fuel injector seal.

Special Tool(s): 310-198

Renew Part: Fuel injector seal Quantity: 1 .
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Using the special tool, correctly located the seal.

Special Tool(s): 310-199
CAUTION: If the original fuel injector is being installed, the original fuel injector clamp must be installed with the fuel injector it was removed with.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Install the injector clamp.
CAUTION: If a new cylinder head has been installed then the special tool 310-200-02 without the thread must be used to install the fuel rail.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Insert the special tools.

Special Tool(s): 310-200-01 , 310-200-02
CAUTION: When installing the fuel injector(s), make sure that the Teflon seal is clean and free of foreign material and lubricant.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Install the fuel left side injectors.
Install the fuel rail.
Refer to: LEFT FUEL RAIL

Refer to: RIGHT FUEL RAIL
Install the engine cover.
Refer to: ENGINE COVER - V6 S/C 3.0L PETROL
Connect the startup battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT