LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2018 >> Range Rover Velar Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Engine Cooling - INGENIUM I4 2.0L Diesel -- Range Rover Velar/L560) >> Engine Cooling - INGENIUM I4 2.0L Diesel >> Removal And Installation >> Radiator (G2135289) >> Installation

Radiator (G2135289): Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the radiator assembly into the correct position. Make sure that the 2 retaining clips are correctly located.
  2. Install the radiator support brackets and tighten the 2 bolts to the correct torque.

    Torque  : 5 Nm 

  3. Install the cooling fan and motor shroud.

    Refer to: ELECTRIC COOLING FAN AND SHROUD 

  4. Connect the startup battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT

scientia non olet · About LEMON Manuals