LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2018 >> Range Rover Velar Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Engine Emission Control - INGENIUM I4 2.0L Diesel -- Range Rover Velar/L560) >> Engine Emission Control - INGENIUM I4 2.0L Diesel >> Removal And Installation >> Low Pressure Exhaust Gas RECIRCULATION Temperature Sensor (G1947550) >> Installation

Low Pressure Exhaust Gas RECIRCULATION Temperature Sensor (G1947550): Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the low pressure EGR temperature sensor.

    Torque  : 3.6 Nm 

  2. Connect the electrical connector for the low pressure EGR temperature sensor.
  3. Install the accessory drive belt.
  4. CAUTION: Make sure that the accessory drive belt is correctly located on each pulley.

    Release the accessory drive belt tensioner.

  5. Install the intake air resonator.

    Torque  : 9 Nm 

  6. Check and top up the cooling system as required.
  7. Install the engine cover.
  8. Connect the battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT

scientia non olet · About LEMON Manuals