Crankshaft Pulley (G1947457): Removal

WARNING: This page is about a different variant/trim than selected.

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

Raise and support the vehicle on a suitable 2 post lift.
Refer to: LIFTING
Disconnect the startup battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT
Remove the accessory drive belt tensioner.
Refer to: ACCESSORY DRIVE BELT TENSIONER
Remove the charge air cooler.
Refer to: CHARGE AIR COOLER
Disconnect the electrical connector secured on the charge air cooler bracket.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Release the wiring harness from the intercooler bracket.
- Remove the 2 intercooler bracket nuts.
Remove the 2 bolts and remove the intercooler bracket.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
CAUTION: Only rotate the crankshaft clockwise.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Install the special tool onto the crankshaft pulley.

Special Tool(s): JLR-303-1630
Remove and discard the 4 crankshaft pulley bolts.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the special tool.
  Special Tool(s): JLR-303-1630
- Remove the crankshaft pulley.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Using the special tool remove and discard the front crankshaft seal.

Special Tool(s): JLR-303-1628