LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2018 >> Range Rover Velar Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Engine - INGENIUM I4 2.0L Diesel -- Range Rover Velar/L560 (1 Of 2)) >> Engine - INGENIUM I4 2.0L Diesel >> Removal And Installation >> Crankshaft Front Seal (G1817145) >> Removal

Crankshaft Front Seal (G1817145): Removal

WARNING: This page is about a different variant/trim than selected.
NOTE:
  • This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
  • This procedure contains illustrations showing certain components removed to provide extra clarity.
  1. Raise and support the vehicle on a suitable 2 post lift.

    Refer to: LIFTING

  2. Disconnect the startup battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT

  3. Remove the crankshaft pulley.

    Refer to: CRANKSHAFT PULLEY 

  4. G11714698Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Using the special tool remove and discard the front crankshaft seal.

    Special Tool(s): JLR-303-1628 

scientia non olet · About LEMON Manuals