Crankshaft Position Sensor (G1885342): Installation

WARNING: This page is about a different variant/trim than selected.

CAUTION: Make sure that the component is clean, free of foreign material and lubricant.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Install the Crankshaft Position (CKP) sensor.
- Install the CKP retaining bolt.
  Torque : 5 Nm
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Install the grommet.
CAUTION: Apply Loctite 243 to the bolts.

NOTE: Make sure to clean the threads prior to installation.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Install the 5 turbocharger support bracket retaining bolts.
  Torque : 32 Nm
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Connect the electrical connector and install the retaining clip.
Install the engine undershield.
Refer to: ENGINE UNDERSHIELD
Connect the startup battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT