LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2018 >> Range Rover Velar Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Fuel Charging And Controls - Turbocharger - INGENIUM I4 2.0L Diesel -- Range Rover Velar/L560) >> Fuel Charging And Controls - Turbocharger - INGENIUM I4 2.0L Diesel >> Diagnosis And Testing >> Turbocharger (G1851013) >> Inspection And Verification >> Pinpoint Test B: Oil Level Check

Pinpoint Test B: Oil Level Check

WARNING: This page is about a different variant/trim than selected.
  1. B1: OIL LEVEL CHECK 
    G11714627Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
    1. Check the engine oil level.

      Is the engine oil level below minimum?

      Yes:  Visually inspect the engine for obvious engine leaks. If a leak is identified, rectify as required and retest.

      No:  GO to  B2.

  2. B2: OIL LEVEL CHECK 
    1. Check the engine oil level.

      Is the engine oil level above maximum?

      Yes:  Drain the oil and top up to the maximum position on the dipstick. GO to  C1.

      No:  GO to  B4.

  3. B3: CHECK THE FUEL IN OIL LEVEL 
    1. Connect the JLR approved battery support unit. Jaguar Land Rover approved battery support unit 
    2. Connect the JLR approved diagnostic equipment to the vehicle and begin a new session. Jaguar Land Rover approved diagnostic equipment 

      use DID 03E1 Is the fuel in oil level above %? 

      Yes:  Complete a oil and filter change and reset the fuel in oil level and retest. Refer to: ENGINE OIL VACUUM DRAINING AND FILLING

      No:  GO to  B4.

  4. B4: OIL LEVEL CHECK 
    1. Check the engine oil level.

      Is the engine oil level between the minimum and maximum marks on the dipstick?

      Yes:  GO to PINPOINT TEST C .

      No:  GO to  B1.