LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2018 >> Range Rover Velar Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Electronic Engine Controls - INGENIUM I4 2.0L Diesel -- Range Rover Velar/L560) >> Electronic Engine Controls - INGENIUM I4 2.0L Diesel >> Removal And Installation >> Post Selective Catalyst Reduction Soot Sensor (G2269993) >> Installation

Post Selective Catalyst Reduction Soot Sensor (G2269993): Installation

WARNING: This page is about a different variant/trim than selected.
  1. CAUTION:
    • Make sure that the mating faces are clean and free of foreign material.
    • Make sure the anti-seize compound does not contact the post selective catalyst reduction soot sensor tip.
    • If accidentally dropped or knocked install a new post selective catalyst reduction soot sensor.

    Install the post selective catalyst reduction soot sensor.

  2. Install the post selective catalyst reduction soot sensor module.
    • Connect the electrical connector.
    • Secure the wiring harness to the 2 clips.
    • Install the right side undershield.
    • Install the 8 screws.
    • Install the 5 bolts.
    • Install the 3 nuts.
    • Install the air deflector.
    • Install the 3 fasteners.
    • Install the centre undershield.
    • Install the 2 nuts.
    • Install the 4 bolts.
  7. Connect the startup battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT

scientia non olet · About LEMON Manuals